About Us

Ever wondered how we make badges?

Designs are created or supplied (by you) then moulds or dies cut – an intricate process in itself.

The next process involves pressing (eg: The equivalent weight of 24 x elephants jumping on your badge) and trimming the small blanks of metal (copper or brass), a fitting(brooch/ tie tack) is attached the back then electroplated (gold, silver, nickel, copper, etc).

The final process involves colour filling and a resin finishing coat. Finally your badge is ready to freight.

Badgemakers - Past

99

YEARS
Badgemakers - Present

To enable us to supply your order in the given time, we require the following:

Good quality high resolution artwork(.eps, .ai, .cdr) and upon signed acceptance of our quotation, we will require approximately four weeks to manufacture. Sampling is available upon request.

A deposit of 50% is required upon acceptance with the balance payable on completion of your order.